Deck-Cee™

DECK-CEE™ RE-ROOF SYSTEM
CLIPS AND CEES SUPPORT NEW ROOFS OVER "OLD" METAL ROOFS

USER FRIENDLY CLIPS AND TUBES EASILY STOCKED				TWO COMPONENTS FOR ANY TYPE OF "OLD" METAL ROOF
	ERECTION PROCEDURE 1. Mechanically fasten clips through "old" roof into purlins. 2. Fasten CEES to the clips. 3. Fasten new metal roofing to the DECK CEES.

THE CLIPS AND CEES FOR THIS "SIMPLE" RE-ROOF SYSTEM ARE READILY AVAILABLE AND ARE COMBINED TO FUNCTION AS THE BASE FOR YOUR NEW METAL ROOF. THE SIZE OF THE CEE USED IS A FUNCTION OF THE SPACING OF THE ROOF PURLINS AND THE SPACING OF THE CLIPS.

THE STANDARD ZEE CLIP IS 3" DEEP AND CLEARS THE DEPTH OF MOST EXISTING METAL ROOFS. ADDITION OF THE DEPTH OF THE CEE ALLOWS FOR THE INSERTION OF INSULATION.

THE TABLE BELOW LISTS THE DESIGN CRITERIA OF THE CEE. A SIMPLE CALCULATION OF THE STRESS IN THE CEE ENABLES YOU TO DETERMINE THE SPACING OF THE CLIPS.

CEE SECTION	THICKNESS GAUGE	FY	MOMENT OF INERTIA	SECTION MODULUS	Mr (FT-LB)
1-1/2" X 3-1/2"	18	45	0.175	0.171	423

THE SIMPLICITY OF THE SYSTEM ASSURES LOW LABOR COSTS. THE COST OF THE COMPONENTS IS LESS THAN 40¢ / S.F.

EXAMPLE:
ASSUME        (a) = 5'
                        (b) = 4'
                        (c) = 40 p.s.i.

CALCULATION:
f=1/10 x 40 x 5 x 4² x 12 = 22,486 p.s.i. <30,000 p.s.i.
0.171

STRESS FORMULA:
f = 1/10 (c) x (a) x (b)² x 12
section modules
(a) = SPACING OF ROOF PURLINS
(b) = SPACING OF CLIPS
(c) = DESIGN LOAD

Note: ALLOWABLE STRESS IS 30,000 p.s.i.

-- CONTACT US FOR PRICING ON INDIVIDUAL PROJECTS --

If you should have any questions concerning Decks, Inc. or how we may help your company, feel free to use any of the following means:

email	frankc@roofdecks.net
snail mail	Decks, Incorporated PO Box 278 Woodstock, IL 60098
Telephone	815-337-2030
Fax	815-337-2031

	Home
	Information about Decks, Inc
	What is Gyp-Deckmate™?
	Message to Roofers
	What is Steel Deckmate™?
	What is Versaroof®?

These pages created by Engineered Software Products, Inc.